This harness is a 2m long, two wire non polarity harness to fit a MAC Valve boost solenoid. It has a stock Toyota ECU pin crimped to one wire, which pushes into pin B60 on the stock GE and GTE non vvti ECU connector. The other wire is two be connected to 12V switched/ignition wire. The wires are labelled to there destinations and instructions for install are included.

The MAC valve side of the harness has a two pin connector (MALE & FEMALE), and two self soldering heat shrink tubes to splice to your MAC valve solenoid wires.

'NOTE', if you choose to also purchase the MAC valve with this harness, the connector will be already crimped to the MAC valve and expandable braid has been fitted onto the Mac valve wires to make a professional finished terminated solenoid harness ready to be installed.

Will fit both USDM and JDM cars.

This is one of many Supravworld mini harnesses that you can add to your factory harness (or custom harness). With an aftermarket ECU, you can control every aspect of your engine.

You can also turbocharge your car with the engine still in the car and fit all the extra mini harnesses to run it without needing a full custom harness made.